ATMEGA16APU PDIP-40
$7.00
The low-power, high-performance CMOS 8/16-bit microcontroller is based on the Microchip AVR® enhanced RISC architecture. The device features 16 KB self-programming flash program memory, 1024B SRAM, 512B EEPROM, 8-channel 10-bit A/D converter, and a JTAG interface for on-chip-debug. The device achieves 16 MIPS throughput at 16 Mhz at 2.7-5.5V operation.
By executing powerful instructions in a single clock cycle, the device achieves throughputs approaching one MIPS per MHz, allowing you to optimize power consumption versus processing speed.
Security policy
Delivery policy
Return policy
Features
- High-performance, Low-power Atmel AVR 8-bit Microcontroller
- Advanced RISC Architecture ̶ 131 Powerful Instructions
– Most Single-clock Cycle Execution
̶ 32 x 8 General Purpose Working Registers
̶ Fully Static Operation ̶ Up to 16MIPS Throughput at 16MHz
̶ On-chip 2-cycle Multiplier
- High Endurance Non-volatile Memory segments
̶ 16KBytes of In-System Self-programmable Flash program memory
̶ 512Bytes EEPROM ̶
1KByte Internal SRAM
̶ Write/Erase Cycles: 10,000 Flash/100,000 EEPROM
̶ Data retention: 20 years at 85°C/100 years at 25°C(1)
̶ Optional Boot Code Section with Independent Lock Bits
- In-System Programming by On-chip Boot Program
- True Read-While-Write Operation
̶ Programming Lock for Software Security
- JTAG (IEEE std. 1149.1 Compliant) Interface
̶ Boundary-scan Capabilities According to the JTAG Standard
̶ Extensive On-chip Debug Support
̶ Programming of Flash, EEPROM, Fuses, and Lock Bits through the JTAG Interface
- Peripheral Features
̶ Two 8-bit Timer/Counters with Separate Prescalers and Compare Modes
̶ One 16-bit Timer/Counter with Separate Prescaler, Compare Mode, and Capture Mode
̶ Real Time Counter with Separate Oscillator
̶ Four PWM Channels ̶ 8-channel, 10-bit ADC z 8 Single-ended Channels
- 7 Differential Channels in TQFP Package Only
- 2 Differential Channels with Programmable Gain at 1x, 10x, or 200x
̶ Byte-oriented Two-wire Serial Interface
̶ Programmable Serial USART ̶ Master/Slave SPI Serial Interface
̶ Programmable Watchdog Timer with Separate On-chip Oscillator
̶ On-chip Analog Comparator
- Special Microcontroller Features
̶ Power-on Reset and Programmable Brown-out Detection
̶ Internal Calibrated RC Oscillator
̶ External and Internal Interrupt Sources
̶ Six Sleep Modes: Idle, ADC Noise Reduction, Power-save, Power-down, Standby and Extended Standby
- I/O and Packages
̶ 32 Programmable I/O Lines
̶ 40-pin PDIP, 44-lead TQFP, and 44-pad QFN/MLF
- Operating Voltages
̶ 2.7 - 5.5V z Speed Grades
̶ 0 - 16MHz
- Power Consumption @ 1MHz, 3V, and 25°C
̶ Active: 0.6mA
̶ Idle Mode: 0.2mA
̶ Power-down Mode: < 1µA
chat
Comments (0)
No customer reviews for the moment.
8 other products in the same category:
The low-power, high-performance CMOS 8/16-bit microcontroller is based on the Microchip AVR® enhanced RISC architecture. The device features 16 KB self-programming flash program memory, 1024B SRAM, 512B EEPROM, 8-channel 10-bit A/D converter, and a JTAG interface for on-chip-debug. The device achieves 16 MIPS throughput at 16 Mhz at 2.7-5.5V operation.
By executing powerful instructions in a single clock cycle, the device achieves throughputs approaching one MIPS per MHz, allowing you to optimize power consumption versus processing speed.